Send SMS
+918068094444
Home » Products » Bandochain » Water Treatment Chains

Water Treatment Chains

BCS-Type
Comprised of 13Cr stainless steel components. Outstandingly abrasion-resistant and corrosion-resistant. Basic BCS-Type Water Treatment Chain. Bucket is attached to elevate wet sand
BCS-Type
Comprised of 13Cr stainless steel components. Outstandingly abrasion-resistant and corrosion-resistant. Bucket is attached to elevate wet sand
Chain Sprocket
close
Chain Sprocket
BAC-Type
Corrosion resistance and toughness are especially important. We normalize the chain to be used in distinction to suit your needs there is a wide range of selection. We also produce offset links. Please run this chain at least 2-3 times/week to prevent damage from shells, or other sea creatures.
Driving Chain
close
Driving Chain
BBF Type
Each part uses 13Cr stainless steel with chromium-based treatment QT (temper) which is very strong and extremely resistant to corrosion. Pin’s outer diameter is larger to assist in advanced abrasion resistance. Sprockets can be used with KS roller chains.
Water Treatment Chain
close
Water Treatment Chain
BWC Type
Thermal power plants, steel mills, etc. which use cold water in their automatic smelting process mainly use 13Cr chromium stainless steels. Depending on working conditions, 304 series, 316, etc. materials are also available. The corrosion and wear resistance required for the friction of air and water is excellent and can be changed depending on the environmental conditions. Such customization exists such as the material of the rollers; special resins, etc. so please contact us for exact specifications.
C Type Chain
close
C Type Chain
BD400-C-Type
The body is molded integrally with the chain link and barrel part and is assembled by inserting a carbon steel pin. Very durable and widely applicable chain. The head is cast in order to keep the pin from turning and is fixed to the end portion of the pin for easy assembly/disassembly; if assembly/disassembly is not needed, we can secure (cast) both ends. Standard pintle chains are referred to as 400-Series pintle chains which share the same classification as detachable chains with the same pitch dimensions, therefore they can be used in conjunction with the same sprockets.
BDH-C-Type
A rib is attached to the underside of the chain and trope’s inner part or upper surface, which only comes into contact with the upper surface. The area of the sliding part is designed wide to reduce the wear of the chain surface. The load won’t cause sinking while conveying thus the degree of pitch can be maintained.
C-Type Chain
close
C-Type Chain
BD700-C-Type Chain
Among the features that can be used are corrosion and rust resistance for seawater or other contaminated water. These chains are especially wear resistant toward such harsh environments as found in sewage collectors and are designed with long pitches for power and can withstand the wear. Stronger attachments are available to be used with large scrapers or buckets.700 series chains chains are used in batcher plants to transport sand and gravel with bucket elevators and must withstand sever wear from the abrasive materials.
CB Type Chain
close
CB Type Chain
BD700 CB Type Chain
Mainly for use in sewage treatment plants, pump relay, grit collectors, power plants, seawater intake and bar-screen facilities. Ultra-tough chains


Back to top