Send SMS
+918068094444
Home » Products » Bandochain » Standard Conveyor Chain & Sprockets

Standard Conveyor Chain & Sprockets

{
close
{"Slat Conveyor Chains","Slat Conveyor Chains"}
F Type
Used with R type rollers and attaches a flange to guide the chain down the rail. Mainly used with a large-sized inclined or horizontal conveyor.
{
close
{"Flange Roller Chain","Flange Roller Chain"}
R Type
Diameter of the roller is greater than the plate width. Most commonly used type of conveyor chain. Usually used in small, medium-sized horizontal or inclined conveyors
{
close
{"Bucket Elevator Chain","Bucket Elevator Chain"}
S, M Tipe
The roller diameter is less than the width of the link plate. Typically used in bucket elevators for the purpose of protecting sprocket teeth and bushes.
{
close
{"Bearing Roller Chains","Bearing Roller Chains"}
05
When the bearing is mounted to R or F type chains, rotational friction is lessened thereby reducing the loss in drive power. Therefore, the maximum allowable load is increased when compared with standard rollers.
{
close
{"Drive Chains","Drive Chains"}
A Type
These attachments have bent link plates attachable to only one side of the chain. Each of the bolt holes is numbered A1, A2, and A3, respectively.
{
close
{"Welded Chain","Welded Chain"}
08
Attachments are welded at an angle to the main chain body.
{
close
{"Conveyor Chains","Conveyor Chains"}
G Type
Formed to either have bolt holes (for attachments) on one side or both sides of the link plate. Bolt holes are drilled to form G2 and G4 holes, respectively. G type attachments consist of two types; those with two bolt holes are G2, while those with 4 holes are G4.
{
close
{"Bushed Chains","Bushed Chains"}
BUSHED Type
Bush plays the role of the roller. Like with trolley conveyors, the sole role of the chain is for load tension transference , according to weight To carry by attaching a separate roller It is mainly used in the design of conveyor
{
close
{"Bagasse Carrier Chain","Bagasse Carrier Chain"}
SA, SK Type


Back to top